42213 Sarah Way, Temecula, CA 92590,
Tel: 800-854-8530 (USA)
For Micro & Mighty Series Digital Panel Meters,
Counters, Timers & Large Digit Displays
Setup, Calibration, Linearization, Datalogging,
and Ethernet Software
(7.5 MB self-extracting zipped file).
Micro Setup & Calibration Software can simplify setup of Micro
Series meters, counters and remote displays compared to programming
these units from the front panel. Requirements are a PC, an
RS232, USB or Ethernet communications board, and this software, which can be downloaded at no
charge. Following setup, the communications board can be removed if desired.
(200 KB, executable file).
Custom Curve Linearization is a capability of Micro
process meters, strain gauge meters, load cell meters, counters and
totalizers. Requirements are the Extended meter or counter ordering
option, an external
PC, an RS232 option board, and this software, which can be downloaded
at no charge. Following linearization, the RS232 board can be removed
(3.5 MB, executable file).
Data Logging from up to 31 digital
panel meters and counters connected to a PC via a single RS485 data line
is possible with Micro Windows based datalogging software. PC
screens can display up to 64 simulated meters, which can be mathematical combinations of meter readings as well as totalized analog readings. Data
can be captured in disk in the form of ASCII files for graphing and
analysis using a program such as MS Excel. Requirements are a PC, an
RS232, USB or Ethernet communications board, and this software, which can be downloaded at no charge.
(4.0 MB, executable file).
Installs our Windows-based Node Manager Software, which runs on a host
computer and is used to configure our Ethernet Nodes. It automatically
discovers all Nodes on a LAN or WAN, plus any devices connected to each
Server Node via an RS485 bus. It is used to configure each Node, such as
setting communication parameters, naming the Node and associated
devices, entering email addresses for alarm notification and data
requests, selecting the Node's time zone for time-stamping of emails and
streaming data, and upgrading firmware. Once configuration data has been
stored in flash memory of all Nodes, Node Manager Software can be
closed. To install, download the file into its own directory such as
c:\temp2. Double-click on the file to unzip it, then double-click on
setup.exe to install. Please see our Ethernet Communications Manual for
(341 kB) is the latest revision of our Node Firmware, which resides in
flash memory of our Ethernet Nodes. It is required for Node operation
and includes a web server for Node discovery and setup. To see if a Node
needs a firmware upgrade to this version, open the Node with Node
Manager Software and click on the Firmware Upgrade tab. If the version
on this web page is higher than the version currently in the Node,
perform the upgrade. To upgrade, click on above link and save the text
file in a directory such as C:\Program Files\NodeMgr\. Then follow the
instructions under the Firmware Upgrade tab. Upgrading will not affect
data stored in the Node.